If you are planning to study Production Engineering at Enugu State University of Science & Technology located in Enugu State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. ESUT was established in 1980 as Anambra State University of Technology before becoming Enugu State University of Science and Technology in 1991 following the creation of Enugu State. It is recognized as one of Nigeria’s pioneering universities of technology. This page explains everything you need to know to increase your chances of gaining admission into ESUT.
Does Enugu State University of Science & Technology (ESUT) offer Production Engineering?
No, Enugu State University of Science & Technology does not offer Production Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Enugu State University of Science & Technology (ESUT) below to check if the Production Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Production Engineering When Accredited in Enugu State University of Science & Technology (ESUT)
O’Level Requirements
To study this course, candidates seeking admission into the Production Engineering department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
ESUT Cut-Off Mark for Production Engineering
The general UTME cut-off mark is 180, but due to the variation of Production Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from ESUT Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other ESUT Science Courses with their Requirements
1. Electrical / Electronics Technology Education
To study this course, candidates seeking admission into the Electrical / Electronics Technology Education department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
2. Agriculture
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Agriculture department.
Biology / Agricultural Science,
Mathematics / Physics, and
3. Building
To study this course, the minimum requirement for applicants seeking admission to the Building department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be;
Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
4. Education and Integrated Science
To study this course, candidates seeking admission into the Education and Integrated Science department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Any other four (4) relevant subjects
5. Metallurgical and Material Engineering
To study this course, candidates seeking admission into the Metallurgical and Material Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
one other Science subject.
6. Physical and Health Education
To study this course, candidates aspiring to gain admission into Physical and Health Education department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology or its equivalent
and any two (2) other relevant subjects.
7. Agronomy
To study this course, candidates aspiring to gain admission into Agronomy department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Nigerian Tertiary Institutions Offering Production Engineering Course