If you are planning to study Remote Sensing and Geosciences Information System at Enugu State University of Science & Technology located in Enugu State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into ESUT.
Does Enugu State University of Science & Technology (ESUT) offer Remote Sensing and Geosciences Information System?
No, Enugu State University of Science & Technology does not offer Remote Sensing and Geosciences Information System under its Faculty of Earth and Mineral Sciences. However, since our course list is updated regularly, you can visit the courses available at Enugu State University of Science & Technology (ESUT) below to check if the Remote Sensing and Geosciences Information System course under the Faculty of Earth and Mineral Sciences has been updated.
Admission Requirements for Remote Sensing and Geosciences Information System When Accredited in Enugu State University of Science & Technology (ESUT)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Remote Sensing and Geosciences Information System department under Faculty of Earth and Mineral Sciences, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further. Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall, Joinery,
Floors and Ceiling Finishing, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity.
JAMB Subject Combination
Art, Biology and Economics.
ESUT Cut-Off Mark for Remote Sensing and Geosciences Information System
The general UTME cut-off mark is 180, but due to the variation of Remote Sensing and Geosciences Information System cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from ESUT Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other ESUT Science Courses with their Requirements
Surveying and Geoinformatics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Surveying and Geoinformatics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Joinery, Carpentry, Decorative Painting, Lining, Sign & Design, Wall Hanging, Colour Mixing / Matching & Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity,
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block Laying, Concreting, Wall, Floors and Ceiling Finishing.
Geology and Mining
SSCE Requirements
To study this course, candidates seeking admission into the Geology and Mining department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any one other relevant subject.
Education and Biology
SSCE Requirements
To study this course, candidates seeking admission into the Education and Biology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Physical and Health Education
SSCE Requirements
To study this course, candidates seeking admission into the Physical and Health Education department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology or its equivalent
and any two (2) other relevant subjects.
Microbiology
SSCE Requirements
To study this course, candidates seeking admission into the Microbiology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Anatomy
SSCE Requirements
To study this course, candidates aspiring to gain admission into Anatomy department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Technology and Vocational Education
SSCE Requirements
To study this course, candidates seeking admission into the Technology and Vocational Education department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any three (3) other relevant subjects.
Nigerian Tertiary Institutions Offering Remote Sensing and Geosciences Information System Course