If you are planning to study Wood Production Engineering at Federal Polytechnic, Ede located in Osun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into EDEPOLY.
Does Federal Polytechnic, Ede (EDEPOLY) offer Wood Production Engineering?
No, Federal Polytechnic, Ede does not offer Wood Production Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Federal Polytechnic, Ede (EDEPOLY) below to check if the Wood Production Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Wood Production Engineering When Accredited in Federal Polytechnic, Ede (EDEPOLY)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Wood Production Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
EDEPOLY Cut-Off Mark for Wood Production Engineering
The general UTME cut-off mark is 180, but due to the variation of Wood Production Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from EDEPOLY Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other EDEPOLY Science Courses with their Requirements
Computer Science (CS)
SSCE Requirements
To study this course, candidates seeking admission into the Computer Science (CS) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other Science subjects.
Horticultural Technology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Horticultural Technology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other relevant subjectes.
Civil Engineering
SSCE Requirements
To study this course, candidates aspiring to gain admission into Civil Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Nutrition and Dietetics
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Nutrition and Dietetics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology/Agricultural Science.
Computer Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Computer Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Surveying and Geoinformatics
SSCE Requirements
To study this course, candidates seeking admission into the Surveying and Geoinformatics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Joinery, Carpentry, Decorative Painting, Lining, Sign & Design, Wall Hanging, Colour Mixing / Matching & Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity,
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block Laying, Concreting, Wall, Floors and Ceiling Finishing.
Electrical / Electronics Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Electrical / Electronics Engineering department.
any other Science subject.
Nigerian Tertiary Institutions Offering Wood Production Engineering Course