If you are planning to study Mechanical and Metallurgical Engineering at Federal University, Lafia located in Nasawara State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. FULAFIA was established in 2011 by the Federal Government of Nigeria as one of the newly created federal universities designed to increase educational opportunities and contribute to socioeconomic development through higher education. This page explains everything you need to know to increase your chances of gaining admission into FULAFIA.
Does Federal University, Lafia (FULAFIA) offer Mechanical and Metallurgical Engineering?
No, Federal University, Lafia does not offer Mechanical and Metallurgical Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Federal University, Lafia (FULAFIA) below to check if the Mechanical and Metallurgical Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Mechanical and Metallurgical Engineering When Accredited in Federal University, Lafia (FULAFIA)
O’Level Requirements
To study this course, candidates seeking admission into the Mechanical and Metallurgical Engineering department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
one (1) other Science subject.
FULAFIA Cut-Off Mark for Mechanical and Metallurgical Engineering
The general UTME cut-off mark is 180, but due to the variation of Mechanical and Metallurgical Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from FULAFIA Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other FULAFIA Science Courses with their Requirements
1. Radiography
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Radiography department.
2. Forestry and Wildlife Management
To study this course, candidates aspiring to gain admission into Forestry and Wildlife Management department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Further Mathematics and Statistics.
3. Geology
To study this course, the minimum requirement for applicants seeking admission to the Geology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other relevant subject.
4. Anatomy
To study this course, candidates aspiring to gain admission into Anatomy department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
5. Agriculture
To study this course, candidates aspiring to gain admission into Agriculture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology / Agricultural Science,
Mathematics / Physics, and
6. Zoology
To study this course, candidates seeking admission into the Zoology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
two (2) other Science subject.
7. Education and Integrated Science
To study this course, the minimum requirement for applicants seeking admission to the Education and Integrated Science department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Any other four (4) relevant subjects
Nigerian Tertiary Institutions Offering Mechanical and Metallurgical Engineering Course