If you are planning to study Chemical and Polymer Engineering at Federal University Ndufu Alike, Ikwo located in Ebonyi State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. FUNAI was established in 2011 by the Federal Government of Nigeria as part of a nationwide initiative to establish new federal universities. The institution was created to broaden access to quality higher education and foster research and innovation. This page explains everything you need to know to increase your chances of gaining admission into FUNAI.
Does Federal University Ndufu Alike, Ikwo (FUNAI) offer Chemical and Polymer Engineering?
No, Federal University Ndufu Alike, Ikwo does not offer Chemical and Polymer Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Federal University Ndufu Alike, Ikwo (FUNAI) below to check if the Chemical and Polymer Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Chemical and Polymer Engineering When Accredited in Federal University Ndufu Alike, Ikwo (FUNAI)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Chemical and Polymer Engineering department under Faculty of Engineering / Technology.
any other Science subject.
FUNAI Cut-Off Mark for Chemical and Polymer Engineering
The general UTME cut-off mark is 180, but due to the variation of Chemical and Polymer Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from FUNAI Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other FUNAI Science Courses with their Requirements
1. Surveying and Geoinformatics
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Surveying and Geoinformatics department.
Joinery, Carpentry, Decorative Painting, Lining, Sign & Design, Wall Hanging, Colour Mixing / Matching & Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity,
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block Laying, Concreting, Wall, Floors and Ceiling Finishing.
2. Anatomy
To study this course, candidates aspiring to gain admission into Anatomy department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
3. Geology
To study this course, candidates seeking admission into the Geology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other relevant subject.
4. Botany
To study this course, candidates aspiring to gain admission into Botany department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
5. Applied Geophysics
To study this course, candidates seeking admission into the Applied Geophysics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
6. Statistics
To study this course, candidates seeking admission into the Statistics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other relevant subject.
7. Physical and Health Education
To study this course, the minimum requirement for applicants seeking admission to the Physical and Health Education department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology or its equivalent
and any two (2) other relevant subjects.
Nigerian Tertiary Institutions Offering Chemical and Polymer Engineering Course