If you are planning to study Software Engineering at Federal University Ndufu Alike, Ikwo located in Ebonyi State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. FUNAI was established in 2011 by the Federal Government of Nigeria as part of a nationwide initiative to establish new federal universities. The institution was created to broaden access to quality higher education and foster research and innovation. This page explains everything you need to know to increase your chances of gaining admission into FUNAI.
Does Federal University Ndufu Alike, Ikwo (FUNAI) offer Software Engineering?
No, Federal University Ndufu Alike, Ikwo does not offer Software Engineering under its Faculty of Data and Decision Sciences. However, since our course list is updated regularly, you can visit the courses available at Federal University Ndufu Alike, Ikwo (FUNAI) below to check if the Software Engineering course under the Faculty of Data and Decision Sciences has been updated.
Admission Requirements for Software Engineering When Accredited in Federal University Ndufu Alike, Ikwo (FUNAI)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Software Engineering department under Faculty of Data and Decision Sciences, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subjects.
JAMB Subject Combination
Biology, Chemistry, Agric Science, Economics and Geography.
FUNAI Cut-Off Mark for Software Engineering
The general UTME cut-off mark is 180, but due to the variation of Software Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from FUNAI Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other FUNAI Science Courses with their Requirements
1. Surveying and Geoinformatics
To study this course, candidates aspiring to gain admission into Surveying and Geoinformatics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Joinery, Carpentry, Decorative Painting, Lining, Sign & Design, Wall Hanging, Colour Mixing / Matching & Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity,
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block Laying, Concreting, Wall, Floors and Ceiling Finishing.
2. Geology and Geophysics
To study this course, candidates aspiring to gain admission into Geology and Geophysics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
3. Education and Biology
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Biology department.
4. Applied Geophysics
To study this course, candidates seeking admission into the Applied Geophysics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
5. Mechatronics Engineering
To study this course, candidates seeking admission into the Mechatronics Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
6. Microbiology
To study this course, the minimum requirement for applicants seeking admission to the Microbiology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
7. Zoology
To study this course, the minimum requirement for applicants seeking admission to the Zoology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subject.
Nigerian Universities Offering Software Engineering Course