If you are planning to study Automobile Engineering at Federal University of Technology Akure located in Ondo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into FUTA.
Does Federal University of Technology Akure (FUTA) offer Automobile Engineering?
No, Federal University of Technology Akure does not offer Automobile Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Federal University of Technology Akure (FUTA) below to check if the Automobile Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Automobile Engineering When Accredited in Federal University of Technology Akure (FUTA)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Automobile Engineering department under Faculty of Engineering / Technology.
any other Science subject.
FUTA Cut-Off Mark for Automobile Engineering
The general UTME cut-off mark is 180, but due to the variation of Automobile Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from FUTA Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other FUTA Science Courses with their Requirements
Electrical / Electronics Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Electrical / Electronics Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
Forestry and Wood Technology
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Forestry and Wood Technology department.
Biology / Agricultural Science,
at least ‘O’ Level pass in Physics.
Meteorology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Meteorology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
either Chemistry or Geography.
Applied Geology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Applied Geology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Remote Sensing and Geosciences Information System
SSCE Requirements
To study this course, candidates aspiring to gain admission into Remote Sensing and Geosciences Information System department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further. Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall, Joinery,
Floors and Ceiling Finishing, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity.
Statistics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Statistics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other relevant subject.
Architecture
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Architecture department.
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Nigerian Tertiary Institutions Offering Automobile Engineering Course