If you are planning to study Materials Science and Engineering at Federal University of Technology Akure located in Ondo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. FUTA was established in 1981 by the Federal Government of Nigeria as a university of technology. It was founded to promote technological advancement, scientific research, and the training of highly skilled professionals. This page explains everything you need to know to increase your chances of gaining admission into FUTA.
Does Federal University of Technology Akure (FUTA) offer Materials Science and Engineering?
No, Federal University of Technology Akure does not offer Materials Science and Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Federal University of Technology Akure (FUTA) below to check if the Materials Science and Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Materials Science and Engineering When Accredited in Federal University of Technology Akure (FUTA)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Materials Science and Engineering department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Any other relevant Science Subject
FUTA Cut-Off Mark for Materials Science and Engineering
The general UTME cut-off mark is 180, but due to the variation of Materials Science and Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from FUTA Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other FUTA Science Courses with their Requirements
1. Information System
To study this course, candidates seeking admission into the Information System department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
three (3) other Science subjects.
2. Applied Geology
To study this course, the minimum requirement for applicants seeking admission to the Applied Geology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
3. Mechanical Engineering
To study this course, the minimum requirement for applicants seeking admission to the Mechanical Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other relevant Science subjects.
4. Quantity Surveying (QS)
To study this course, candidates seeking admission into the Quantity Surveying (QS) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any of Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further. Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall, Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity.
5. Biomedical Technology
To study this course, candidates seeking admission into the Biomedical Technology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
6. Metallurgical and Material Engineering
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Metallurgical and Material Engineering department.
one other Science subject.
7. Mathematics
To study this course, candidates aspiring to gain admission into Mathematics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other relevant subjects.
Nigerian Tertiary Institutions Offering Materials Science and Engineering Course