If you are planning to study Technology Education at Federal University of Technology Akure located in Ondo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into FUTA.
Does Federal University of Technology Akure (FUTA) offer Technology Education?
No, Federal University of Technology Akure does not offer Technology Education under its Faculty of Education. However, since our course list is updated regularly, you can visit the courses available at Federal University of Technology Akure (FUTA) below to check if the Technology Education course under the Faculty of Education has been updated.
Admission Requirements for Technology Education When Accredited in Federal University of Technology Akure (FUTA)
O’Level Requirements
To study this course, candidates seeking admission into the Technology Education department under Faculty of Education, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other three (3) relevant subjects.
JAMB Subject Combination
one (1) other Science subject.
FUTA Cut-Off Mark for Technology Education
The general UTME cut-off mark is 180, but due to the variation of Technology Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from FUTA Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other FUTA Science Courses with their Requirements
Applied Geophysics
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Applied Geophysics department.
Architecture
SSCE Requirements
To study this course, candidates seeking admission into the Architecture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Physiology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Physiology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biomedical Technology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Biomedical Technology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Building
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Building department.
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be;
Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
Mechanical Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Mechanical Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant Science subjects.
Meteorology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Meteorology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
either Chemistry or Geography.
Nigerian Tertiary Institutions Offering Technology Education Course