If you are planning to study Physics with Computational Modeling at Federal University of Technology Minna located in Niger State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into FUTMINNA.
Does Federal University of Technology Minna (FUTMINNA) offer Physics with Computational Modeling?
No, Federal University of Technology Minna does not offer Physics with Computational Modeling under its Faculty of Science. However, since our course list is updated regularly, you can visit the courses available at Federal University of Technology Minna (FUTMINNA) below to check if the Physics with Computational Modeling course under the Faculty of Science has been updated.
Admission Requirements for Physics with Computational Modeling When Accredited in Federal University of Technology Minna (FUTMINNA)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Physics with Computational Modeling department under Faculty of Science, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Chemistry, Mathematics and
any other Science subject from:
Biology or Agricultural Science.
FUTMINNA Cut-Off Mark for Physics with Computational Modeling
The general UTME cut-off mark is 180, but due to the variation of Physics with Computational Modeling cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from FUTMINNA Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other FUTMINNA Science Courses with their Requirements
Fisheries and Aquaculture
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Fisheries and Aquaculture department.
Biology/Agricultural Science,
Physics/Geography/Economics.
Metallurgical and Material Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Metallurgical and Material Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
one other Science subject.
Surveying and Geoinformatics
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Surveying and Geoinformatics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Joinery, Carpentry, Decorative Painting, Lining, Sign & Design, Wall Hanging, Colour Mixing / Matching & Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity,
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block Laying, Concreting, Wall, Floors and Ceiling Finishing.
Computer Science (CS)
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Computer Science (CS) department.
any two (2) other Science subjects.
Telecommunication Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Telecommunication Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant subjects.
Geography
SSCE Requirements
To study this course, candidates seeking admission into the Geography department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other two (2) Science subjects.
Biochemistry
SSCE Requirements
To study this course, candidates seeking admission into the Biochemistry department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Nigerian Tertiary Institutions Offering Physics with Computational Modeling Course