If you are planning to study Automotive Engineering at Federal University of Technology, Owerri located in Imo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into FUTO.
Does Federal University of Technology, Owerri (FUTO) offer Automotive Engineering?
No, Federal University of Technology, Owerri does not offer Automotive Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Federal University of Technology, Owerri (FUTO) below to check if the Automotive Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Automotive Engineering When Accredited in Federal University of Technology, Owerri (FUTO)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Automotive Engineering department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
FUTO Cut-Off Mark for Automotive Engineering
The general UTME cut-off mark is 180, but due to the variation of Automotive Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from FUTO Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other FUTO Science Courses with their Requirements
Medicine and Surgery
SSCE Requirements
To study this course, candidates aspiring to gain admission into Medicine and Surgery department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biomedical Technology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Biomedical Technology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Radiography
SSCE Requirements
To study this course, candidates aspiring to gain admission into Radiography department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Prosthesis and Orthopaedic Technology
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Prosthesis and Orthopaedic Technology department.
Information Technology
SSCE Requirements
To study this course, candidates seeking admission into the Information Technology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant subjects.
Surveying and Geoinformatics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Surveying and Geoinformatics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Joinery, Carpentry, Decorative Painting, Lining, Sign & Design, Wall Hanging, Colour Mixing / Matching & Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity,
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block Laying, Concreting, Wall, Floors and Ceiling Finishing.
Electrical / Electronics Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Electrical / Electronics Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
Nigerian Tertiary Institutions Offering Automotive Engineering Course