If you are planning to study Petroleum and Gas Engineering at Federal University of Technology, Owerri located in Imo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into FUTO.
Does Federal University of Technology, Owerri (FUTO) offer Petroleum and Gas Engineering?
No, Federal University of Technology, Owerri does not offer Petroleum and Gas Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Federal University of Technology, Owerri (FUTO) below to check if the Petroleum and Gas Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Petroleum and Gas Engineering When Accredited in Federal University of Technology, Owerri (FUTO)
O’Level Requirements
To study this course, candidates seeking admission into the Petroleum and Gas Engineering department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
and any one Science subject.
FUTO Cut-Off Mark for Petroleum and Gas Engineering
The general UTME cut-off mark is 180, but due to the variation of Petroleum and Gas Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from FUTO Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other FUTO Science Courses with their Requirements
Mathematics
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Mathematics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other relevant subjects.
Prosthesis and Orthopaedic Technology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Prosthesis and Orthopaedic Technology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Public Health Technology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Public Health Technology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Building
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Building department.
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be;
Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
Civil Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Civil Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Environmental Management
SSCE Requirements
To study this course, candidates seeking admission into the Environmental Management department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other four (4) relevant subjects plus a pass in English Language.
Agricultural Engineering (AE)
SSCE Requirements
To study this course, candidates seeking admission into the Agricultural Engineering (AE) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Any one other subject from:
Introduction to Agricultural Science,
Materials and Workshop Process and Machining,
Tractor Layout Power Unit Under Carriage and Auto Electricity;
Transmission System;
Implement and Machine;
Principles of Crop Husbandry and Land Use,
Materials and Workshop Processes;
Construction and Maintenance of Agricultural Machines;
General Metal Work;
General Wood Work and Building / Engineering Drawing.
Nigerian Universities Offering Petroleum and Gas Engineering Course