If you are planning to study Metallurgical and Material Engineering at Federal University, Otuoke located in Bayelsa State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into FUOTUOKE.
Does Federal University, Otuoke (FUOTUOKE) offer Metallurgical and Material Engineering?
No, Federal University, Otuoke does not offer Metallurgical and Material Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Federal University, Otuoke (FUOTUOKE) below to check if the Metallurgical and Material Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Metallurgical and Material Engineering When Accredited in Federal University, Otuoke (FUOTUOKE)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Metallurgical and Material Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
one other Science subject.
FUOTUOKE Cut-Off Mark for Metallurgical and Material Engineering
The general UTME cut-off mark is 180, but due to the variation of Metallurgical and Material Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from FUOTUOKE Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other FUOTUOKE Science Courses with their Requirements
Chemical Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Chemical Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
Mechanical Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Mechanical Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant Science subjects.
Mathematics and Statistics
SSCE Requirements
To study this course, candidates seeking admission into the Mathematics and Statistics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology and Additional / Further Mathematics.
Physics With Electronics
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Physics With Electronics department.
any other Science subject from Further Mathematics and Biology / Agricultural Science.
Electrical / Electronics Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Electrical / Electronics Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
Petroleum and Gas Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Petroleum and Gas Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
and any one Science subject.
Chemistry
SSCE Requirements
To study this course, candidates aspiring to gain admission into Chemistry department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Nigerian Universities Offering Metallurgical and Material Engineering Course