If you are planning to study Electrical and Information Engineering at Federal University, Oye-Ekiti located in Ekiti State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. FUOYE was established in 2011 by the Federal Government of Nigeria as part of a nationwide initiative to expand university education. The institution has grown rapidly and is recognized for its commitment to quality teaching and research. This page explains everything you need to know to increase your chances of gaining admission into FUOYE.
Does Federal University, Oye-Ekiti (FUOYE) offer Electrical and Information Engineering?
No, Federal University, Oye-Ekiti does not offer Electrical and Information Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Federal University, Oye-Ekiti (FUOYE) below to check if the Electrical and Information Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Electrical and Information Engineering When Accredited in Federal University, Oye-Ekiti (FUOYE)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Electrical and Information Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other relevant science subject.
JAMB Subject Combination
any other science subject.
FUOYE Cut-Off Mark for Electrical and Information Engineering
The general UTME cut-off mark is 180, but due to the variation of Electrical and Information Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from FUOYE Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other FUOYE Science Courses with their Requirements
1. Plant Science and Biotechnology
To study this course, candidates seeking admission into the Plant Science and Biotechnology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
2. Computer Science (CS)
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Computer Science (CS) department.
any two (2) other Science subjects.
3. Human Kinetics
To study this course, candidates aspiring to gain admission into Human Kinetics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Health Science / Physical Education / Biology
Any other two (2) relevant subjects
4. Anatomy
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Anatomy department.
5. Education and Physics
To study this course, candidates seeking admission into the Education and Physics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
two (2) other Science subjects or NTC / NBC.
6. Chemistry
To study this course, candidates seeking admission into the Chemistry department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
7. Architecture
To study this course, candidates seeking admission into the Architecture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Nigerian Tertiary Institutions Offering Electrical and Information Engineering Course