If you are planning to study Industrial Mathematics at Godfrey Okoye University located in Enugu State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. GOUNI was established in 2009 by the Catholic Diocese of Enugu to provide holistic university education grounded in academic excellence, ethical values, and community development. It has since expanded into one of Nigeria’s leading private universities. This page explains everything you need to know to increase your chances of gaining admission into GOUNI.
Does Godfrey Okoye University (GOUNI) offer Industrial Mathematics?
No, Godfrey Okoye University does not offer Industrial Mathematics under its Faculty of Science. However, since our course list is updated regularly, you can visit the courses available at Godfrey Okoye University (GOUNI) below to check if the Industrial Mathematics course under the Faculty of Science has been updated.
Admission Requirements for Industrial Mathematics When Accredited in Godfrey Okoye University (GOUNI)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Industrial Mathematics department under Faculty of Science.
two (2) other Science subjects.
JAMB Subject Combination
any two (2) other subjects from
Physics, Chemistry, Economics,
Biology and Agricultural Science.
GOUNI Cut-Off Mark for Industrial Mathematics
The general UTME cut-off mark is 180, but due to the variation of Industrial Mathematics cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from GOUNI Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other GOUNI Science Courses with their Requirements
1. Biological Science
To study this course, the minimum requirement for applicants seeking admission to the Biological Science department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Any other relevant Science subject.
2. Biotechnology
To study this course, candidates aspiring to gain admission into Biotechnology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
3. Architecture
To study this course, candidates seeking admission into the Architecture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
4. Biology
To study this course, the minimum requirement for applicants seeking admission to the Biology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Mathematics / Physics and
any one other relevant subject.
5. Geography and Environmental Management
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Geography and Environmental Management department.
any other two (2) Science subjects.
6. Geology and Mining
To study this course, candidates aspiring to gain admission into Geology and Mining department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any one other relevant subject.
7. Physics With Electronics
To study this course, candidates seeking admission into the Physics With Electronics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject from Further Mathematics and Biology / Agricultural Science.
Nigerian Universities Offering Industrial Mathematics Course