If you are planning to study Production Engineering at Godfrey Okoye University located in Enugu State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. GOUNI was established in 2009 by the Catholic Diocese of Enugu to provide holistic university education grounded in academic excellence, ethical values, and community development. It has since expanded into one of Nigeria’s leading private universities. This page explains everything you need to know to increase your chances of gaining admission into GOUNI.
Does Godfrey Okoye University (GOUNI) offer Production Engineering?
No, Godfrey Okoye University does not offer Production Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Godfrey Okoye University (GOUNI) below to check if the Production Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Production Engineering When Accredited in Godfrey Okoye University (GOUNI)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Production Engineering department under Faculty of Engineering / Technology.
any other Science subject.
GOUNI Cut-Off Mark for Production Engineering
The general UTME cut-off mark is 180, but due to the variation of Production Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from GOUNI Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other GOUNI Science Courses with their Requirements
1. Mathematics with Computer Science
To study this course, candidates aspiring to gain admission into Mathematics with Computer Science department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two other relevant subjects.
2. Physical Science
To study this course, the minimum requirement for applicants seeking admission to the Physical Science department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject from:
Biology or Agricultural Science.
3. Education and Mathematics
To study this course, candidates seeking admission into the Education and Mathematics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
one (1) other Science subject, and
any other relevant subjects.
4. Education and Computer Science
To study this course, candidates aspiring to gain admission into Education and Computer Science department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
three (3) other relevant Science subjects.
5. Mathematics
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Mathematics department.
any two (2) other relevant subjects.
6. Computer Science (CS)
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Computer Science (CS) department.
any two (2) other Science subjects.
7. Architecture
To study this course, candidates aspiring to gain admission into Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Nigerian Tertiary Institutions Offering Production Engineering Course