If you are planning to study Metallurgical Engineering at Gombe State University located in Gombe State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. GOMSU was established in 2004 by the Gombe State Government to increase access to higher education and promote research, innovation, and manpower development within the state and beyond. This page explains everything you need to know to increase your chances of gaining admission into GOMSU.
Does Gombe State University (GOMSU) offer Metallurgical Engineering?
No, Gombe State University does not offer Metallurgical Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Gombe State University (GOMSU) below to check if the Metallurgical Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Metallurgical Engineering When Accredited in Gombe State University (GOMSU)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Metallurgical Engineering department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
one other Science subject.
GOMSU Cut-Off Mark for Metallurgical Engineering
The general UTME cut-off mark is 180, but due to the variation of Metallurgical Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from GOMSU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other GOMSU Science Courses with their Requirements
1. Biochemistry
To study this course, candidates seeking admission into the Biochemistry department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
2. Education and Chemistry
To study this course, candidates seeking admission into the Education and Chemistry department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology and Agricultural Science.
3. Education and Mathematics
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Mathematics department.
one (1) other Science subject, and
any other relevant subjects.
4. Architecture
To study this course, candidates seeking admission into the Architecture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
5. Education and Computer Science
To study this course, candidates aspiring to gain admission into Education and Computer Science department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
three (3) other relevant Science subjects.
6. Urban and Regional Planning (URP)
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Urban and Regional Planning (URP) department.
Physics, Chemistry, Economics, Government, Biology, Art, History, IRK/CRK, Social Studies and Tech Drawing.
7. Mathematics
To study this course, candidates aspiring to gain admission into Mathematics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other relevant subjects.
Nigerian Tertiary Institutions Offering Metallurgical Engineering Course