If you are planning to study Crop and Environmental Protection at Gombe State University of Science and Technology located in Gombe State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. GSUTECH was established in 2021 by the Gombe State Government as a specialized university focused on science, technology, engineering, and innovation. The institution was created to strengthen technological education and research in Nigeria. This page explains everything you need to know to increase your chances of gaining admission into GSUTECH.
Does Gombe State University of Science and Technology (GSUTECH) offer Crop and Environmental Protection?
No, Gombe State University of Science and Technology does not offer Crop and Environmental Protection under its Faculty of Agriculture. However, since our course list is updated regularly, you can visit the courses available at Gombe State University of Science and Technology (GSUTECH) below to check if the Crop and Environmental Protection course under the Faculty of Agriculture has been updated.
Admission Requirements for Crop and Environmental Protection When Accredited in Gombe State University of Science and Technology (GSUTECH)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Crop and Environmental Protection department under Faculty of Agriculture, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology / Agricultural Science,
one Science/Social Science subject and at least a pass in Physics.
JAMB Subject Combination
Biology / Agricultural Science and
GSUTECH Cut-Off Mark for Crop and Environmental Protection
The general UTME cut-off mark is 180, but due to the variation of Crop and Environmental Protection cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from GSUTECH Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other GSUTECH Science Courses with their Requirements
1. Information System
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Information System department.
three (3) other Science subjects.
2. Microbiology
To study this course, the minimum requirement for applicants seeking admission to the Microbiology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
3. Architecture
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Architecture department.
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
4. Chemistry
To study this course, candidates aspiring to gain admission into Chemistry department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
5. Biology
To study this course, candidates seeking admission into the Biology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Mathematics / Physics and
any one other relevant subject.
6. Quantity Surveying (QS)
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Quantity Surveying (QS) department.
any of Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further. Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall, Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity.
7. Mathematics
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Mathematics department.
any two (2) other relevant subjects.
Nigerian Tertiary Institutions Offering Crop and Environmental Protection Course