If you are planning to study Polymer Engineering at Gombe State University of Science and Technology located in Gombe State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into GSUTECH.
Does Gombe State University of Science and Technology (GSUTECH) offer Polymer Engineering?
No, Gombe State University of Science and Technology does not offer Polymer Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Gombe State University of Science and Technology (GSUTECH) below to check if the Polymer Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Polymer Engineering When Accredited in Gombe State University of Science and Technology (GSUTECH)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Polymer Engineering department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
GSUTECH Cut-Off Mark for Polymer Engineering
The general UTME cut-off mark is 180, but due to the variation of Polymer Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from GSUTECH Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other GSUTECH Science Courses with their Requirements
Biochemistry
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Biochemistry department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Chemistry
SSCE Requirements
To study this course, candidates aspiring to gain admission into Chemistry department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Information System
SSCE Requirements
To study this course, candidates aspiring to gain admission into Information System department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
three (3) other Science subjects.
Microbiology
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Microbiology department.
Information Technology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Information Technology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other relevant subjects.
Urban and Regional Planning (URP)
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Urban and Regional Planning (URP) department.
Physics, Chemistry, Economics, Government, Biology, Art, History, IRK/CRK, Social Studies and Tech Drawing.
Architecture
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Architecture department.
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Nigerian Tertiary Institutions Offering Polymer Engineering Course