If you are planning to study Structural Engineering at Imo State University, Owerri located in Imo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into IMSU.
Does Imo State University, Owerri (IMSU) offer Structural Engineering?
No, Imo State University, Owerri does not offer Structural Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Imo State University, Owerri (IMSU) below to check if the Structural Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Structural Engineering When Accredited in Imo State University, Owerri (IMSU)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Structural Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
IMSU Cut-Off Mark for Structural Engineering
The general UTME cut-off mark is 180, but due to the variation of Structural Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from IMSU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other IMSU Science Courses with their Requirements
1. Electrical / Electronics Engineering
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Electrical / Electronics Engineering department.
any other Science subject.
2. Building
To study this course, candidates seeking admission into the Building department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be;
Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
3. Agriculture
To study this course, candidates seeking admission into the Agriculture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology / Agricultural Science,
Mathematics / Physics, and
4. Architecture
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Architecture department.
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
5. Public Health
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Public Health department.
6. Education and Mathematics
To study this course, candidates aspiring to gain admission into Education and Mathematics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
one (1) other Science subject, and
any other relevant subjects.
7. Mechanical Engineering
To study this course, the minimum requirement for applicants seeking admission to the Mechanical Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other relevant Science subjects.
Nigerian Tertiary Institutions Offering Structural Engineering Course