If you are planning to study Production Engineering at Kaduna State University located in Kaduna State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. KASU was established in 2004 by the Kaduna State Government to expand access to higher education and promote research, innovation, and human capital development. This page explains everything you need to know to increase your chances of gaining admission into KASU.
Does Kaduna State University (KASU) offer Production Engineering?
No, Kaduna State University does not offer Production Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Kaduna State University (KASU) below to check if the Production Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Production Engineering When Accredited in Kaduna State University (KASU)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Production Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
KASU Cut-Off Mark for Production Engineering
The general UTME cut-off mark is 180, but due to the variation of Production Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from KASU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other KASU Science Courses with their Requirements
1. Building Technology (BT)
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Building Technology (BT) department.
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be; Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
2. Biochemistry
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Biochemistry department.
3. Pharmacy
To study this course, candidates seeking admission into the Pharmacy department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
4. Medical Laboratory Science
To study this course, candidates seeking admission into the Medical Laboratory Science department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
5. Nursing (Science)
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Nursing (Science) department.
6. Geography
To study this course, the minimum requirement for applicants seeking admission to the Geography department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other two (2) Science subjects.
7. Radiography
To study this course, candidates aspiring to gain admission into Radiography department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Nigerian Tertiary Institutions Offering Production Engineering Course