If you are planning to study Polymer and Textile Engineering at Lead City University, Ibadan located in Oyo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into Lead City University.
Does Lead City University, Ibadan (LCU) offer Polymer and Textile Engineering?
No, Lead City University, Ibadan does not offer Polymer and Textile Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Lead City University, Ibadan (LCU) below to check if the Polymer and Textile Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Polymer and Textile Engineering When Accredited in Lead City University, Ibadan (LCU)
O’Level Requirements
To study this course, candidates seeking admission into the Polymer and Textile Engineering department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
Lead City University Cut-Off Mark for Polymer and Textile Engineering
The general UTME cut-off mark is 180, but due to the variation of Polymer and Textile Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Lead City University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Lead City University Science Courses with their Requirements
Architecture
SSCE Requirements
To study this course, candidates aspiring to gain admission into Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Public Health
SSCE Requirements
To study this course, candidates seeking admission into the Public Health department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Nursing (Science)
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Nursing (Science) department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Information System
SSCE Requirements
To study this course, candidates aspiring to gain admission into Information System department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
three (3) other Science subjects.
Environmental Management and Toxicology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Environmental Management and Toxicology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Teacher Education Science
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Teacher Education Science department.
any two (2) other relevant subjects.
Medical Laboratory Science
SSCE Requirements
To study this course, candidates aspiring to gain admission into Medical Laboratory Science department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Nigerian Tertiary Institutions Offering Polymer and Textile Engineering Course