If you are planning to study Metallurgical and Material Engineering at Modibbo Adama University Of Technology located in Adamawa State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. MAUTECH was established in 1981 as a federal university of technology in Yola, Adamawa State, to advance science, engineering, and technological education in Nigeria. This page explains everything you need to know to increase your chances of gaining admission into MAUTECH.
Does Modibbo Adama University Of Technology (MAUTECH) offer Metallurgical and Material Engineering?
No, Modibbo Adama University Of Technology does not offer Metallurgical and Material Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Modibbo Adama University Of Technology (MAUTECH) below to check if the Metallurgical and Material Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Metallurgical and Material Engineering When Accredited in Modibbo Adama University Of Technology (MAUTECH)
O’Level Requirements
To study this course, candidates seeking admission into the Metallurgical and Material Engineering department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
one other Science subject.
MAUTECH Cut-Off Mark for Metallurgical and Material Engineering
The general UTME cut-off mark is 180, but due to the variation of Metallurgical and Material Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from MAUTECH Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other MAUTECH Science Courses with their Requirements
1. Biological Science
To study this course, candidates aspiring to gain admission into Biological Science department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Any other relevant Science subject.
2. Technology and Vocational Education
To study this course, candidates aspiring to gain admission into Technology and Vocational Education department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any three (3) other relevant subjects.
3. Animal Science and Range Management
To study this course, the minimum requirement for applicants seeking admission to the Animal Science and Range Management department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Agricultural Science / Chemistry,
any two other subjects and
at least a pass in English Language and Physics.
4. Electrical / Electronics Education
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Electrical / Electronics Education department.
any other Science subject.
5. Soil Science
To study this course, candidates aspiring to gain admission into Soil Science department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology / Agricultural Science and
any other Science subject.
6. Geography
To study this course, candidates seeking admission into the Geography department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other two (2) Science subjects.
7. Agricultural Technology and Education
To study this course, the minimum requirement for applicants seeking admission to the Agricultural Technology and Education department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology / Agricultural Science,
one other relevant subject.
Nigerian Universities Offering Metallurgical and Material Engineering Course