If you are planning to study Auto and Mechanical Technology Education at Nile University of Nigeria located in Federal Capital Territory (FCT), it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into NUN.
Does Nile University of Nigeria (NUN) offer Auto and Mechanical Technology Education?
No, Nile University of Nigeria does not offer Auto and Mechanical Technology Education under its Faculty of Education. However, since our course list is updated regularly, you can visit the courses available at Nile University of Nigeria (NUN) below to check if the Auto and Mechanical Technology Education course under the Faculty of Education has been updated.
Admission Requirements for Auto and Mechanical Technology Education When Accredited in Nile University of Nigeria (NUN)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Auto and Mechanical Technology Education department under Faculty of Education.
any one (1) of Biology / Agricultural Science; Physics, or Chemistry,
Auto Technical, Technical Drawing / Fine Art, Geography, Health Science Food and Nutrition,
Physical and Health Education, General Science / Integrated Science, Building, Electrical Electronic, Metal Work and Wood Work.
NUN Cut-Off Mark for Auto and Mechanical Technology Education
The general UTME cut-off mark is 180, but due to the variation of Auto and Mechanical Technology Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from NUN Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other NUN Science Courses with their Requirements
Education and Integrated Science
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Education and Integrated Science department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Any other four (4) relevant subjects
Biochemistry
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Biochemistry department.
Petroleum and Gas Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Petroleum and Gas Engineering department.
and any one Science subject.
Architecture
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Architecture department.
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Software Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Software Engineering department.
two (2) other Science subjects.
Computer Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Computer Engineering department.
Mechatronics Engineering
SSCE Requirements
To study this course, candidates aspiring to gain admission into Mechatronics Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
Nigerian Tertiary Institutions Offering Auto and Mechanical Technology Education Course