If you are planning to study Forestry and Wood Technology at Nnamdi Azikiwe University located in Anambra State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into UNIZIK.
Does Nnamdi Azikiwe University (UNIZIK) offer Forestry and Wood Technology?
No, Nnamdi Azikiwe University does not offer Forestry and Wood Technology under its Faculty of Agriculture. However, since our course list is updated regularly, you can visit the courses available at Nnamdi Azikiwe University (UNIZIK) below to check if the Forestry and Wood Technology course under the Faculty of Agriculture has been updated.
Admission Requirements for Forestry and Wood Technology When Accredited in Nnamdi Azikiwe University (UNIZIK)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Forestry and Wood Technology department under Faculty of Agriculture, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology / Agricultural Science,
at least ‘O’ Level pass in Physics.
JAMB Subject Combination
Mathematics / Physics and
Biology / Agricultural Science.
UNIZIK Cut-Off Mark for Forestry and Wood Technology
The general UTME cut-off mark is 180, but due to the variation of Forestry and Wood Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNIZIK Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNIZIK Science Courses with their Requirements
Architecture
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Architecture department.
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Chemical Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Chemical Engineering department.
any other Science subject.
Education and Biology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Education and Biology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Health Education
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Health Education department.
any two (2) other relevant subjects.
Human Kinetics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Human Kinetics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Health Science / Physical Education / Biology
Any other two (2) relevant subjects
Polymer and Textile Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Polymer and Textile Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
Geography and Meteorology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Geography and Meteorology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Arts or Social Science subjects with at least a pass in Mathematics.
Nigerian Tertiary Institutions Offering Forestry and Wood Technology Course