If you are planning to study Industrial Technology Education at Obafemi Awolowo University located in Osun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. OAU was established in 1962 by the Western Region Government of Nigeria as one of the country’s premier universities. It was created to promote academic excellence, research, and national development. This page explains everything you need to know to increase your chances of gaining admission into OAU.
Does Obafemi Awolowo University (OAU) offer Industrial Technology Education?
No, Obafemi Awolowo University does not offer Industrial Technology Education under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Obafemi Awolowo University (OAU) below to check if the Industrial Technology Education course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Industrial Technology Education When Accredited in Obafemi Awolowo University (OAU)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Industrial Technology Education department under Faculty of Engineering / Technology.
three (3) other relevant subjects.
JAMB Subject Combination
one (1) other Science subject.
OAU Cut-Off Mark for Industrial Technology Education
The general UTME cut-off mark is 180, but due to the variation of Industrial Technology Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from OAU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other OAU Science Courses with their Requirements
1. Medical Rehabilitation
To study this course, the minimum requirement for applicants seeking admission to the Medical Rehabilitation department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
2. Building
To study this course, candidates aspiring to gain admission into Building department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be;
Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
3. Soil Science
To study this course, the minimum requirement for applicants seeking admission to the Soil Science department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology / Agricultural Science and
any other Science subject.
4. Urban and Regional Planning (URP)
To study this course, candidates seeking admission into the Urban and Regional Planning (URP) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Physics, Chemistry, Economics, Government, Biology, Art, History, IRK/CRK, Social Studies and Tech Drawing.
5. Medicine and Surgery
To study this course, candidates aspiring to gain admission into Medicine and Surgery department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
6. Pharmacy
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Pharmacy department.
7. Mechanical Engineering
To study this course, the minimum requirement for applicants seeking admission to the Mechanical Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other relevant Science subjects.
Nigerian Tertiary Institutions Offering Industrial Technology Education Course