If you are planning to study Mechatronics and System Engineering at Oduduwa University located in Osun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. Oduduwa University was established in 2009 as a private university in Osun State to promote quality higher education with strong emphasis on cultural values, entrepreneurship, and academic excellence. This page explains everything you need to know to increase your chances of gaining admission into Oduduwa University.
Does Oduduwa University (OUI) offer Mechatronics and System Engineering?
No, Oduduwa University does not offer Mechatronics and System Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Oduduwa University (OUI) below to check if the Mechatronics and System Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Mechatronics and System Engineering When Accredited in Oduduwa University (OUI)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Mechatronics and System Engineering department under Faculty of Engineering / Technology.
any other Science subject.
Oduduwa University Cut-Off Mark for Mechatronics and System Engineering
The general UTME cut-off mark is 180, but due to the variation of Mechatronics and System Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Oduduwa University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Oduduwa University Science Courses with their Requirements
1. Computer Science (CS)
To study this course, candidates seeking admission into the Computer Science (CS) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other Science subjects.
2. Community Health
To study this course, candidates seeking admission into the Community Health department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology/Health Science and
Nutrition, Chemistry, Physics,
Religious Studies, Geography,
Economics, Nigerian Language and
at least a pass in English Language, Food and Nutrition/Home Management.
3. Computer Engineering
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Computer Engineering department.
4. Mechanical Engineering
To study this course, candidates seeking admission into the Mechanical Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant Science subjects.
5. Microbiology
To study this course, candidates aspiring to gain admission into Microbiology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
6. Chemical Engineering Technology
To study this course, candidates seeking admission into the Chemical Engineering Technology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology/Agricultural Science, Technical Drawing, Basic Electronics/Basic Electricity, Auto Mechanics, Metal Work, Woodwork (for Civil Engineering Tech.), Further Mathematics, Geography and Economics / Commerce.
For Marine Engineering and Industrial Safety & Environmental Engineering a pass in Biology is required.
7. Electrical / Electronics Engineering
To study this course, the minimum requirement for applicants seeking admission to the Electrical / Electronics Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
Nigerian Tertiary Institutions Offering Mechatronics and System Engineering Course