If you are planning to study Crop Production and Horticulture at Olusegun Agagu University of Science and Technology formally known as Ondo State University of Science and Technology located in Ondo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. OAUSTECH was established in 2020 by the Ondo State Government to advance science and technology education and promote innovation-driven research for economic development. This page explains everything you need to know to increase your chances of gaining admission into OAUSTECH.
Does Olusegun Agagu University of Science and Technology (OAUSTECH) offer Crop Production and Horticulture?
No, Olusegun Agagu University of Science and Technology does not offer Crop Production and Horticulture under its Faculty of Agriculture. However, since our course list is updated regularly, you can visit the courses available at Olusegun Agagu University of Science and Technology (OAUSTECH) below to check if the Crop Production and Horticulture course under the Faculty of Agriculture has been updated.
Admission Requirements for Crop Production and Horticulture When Accredited in Olusegun Agagu University of Science and Technology (OAUSTECH)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Crop Production and Horticulture department under Faculty of Agriculture.
Biology/Agricultural Science,
one Science/Social Science subject and
at least a pass in Physics.
OAUSTECH Cut-Off Mark for Crop Production and Horticulture
The general UTME cut-off mark is 180, but due to the variation of Crop Production and Horticulture cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from OAUSTECH Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other OAUSTECH Science Courses with their Requirements
1. Mechanical Engineering
To study this course, candidates aspiring to gain admission into Mechanical Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other relevant Science subjects.
2. Fisheries
To study this course, candidates seeking admission into the Fisheries department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology / Agricultural Science,
any other Science subject.
3. Microbiology
To study this course, the minimum requirement for applicants seeking admission to the Microbiology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
4. Statistics
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Statistics department.
any other relevant subject.
5. Polymer Engineering
To study this course, the minimum requirement for applicants seeking admission to the Polymer Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
6. Forestry and Wildlife Management
To study this course, the minimum requirement for applicants seeking admission to the Forestry and Wildlife Management department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Further Mathematics and Statistics.
7. Gas Engineering
To study this course, candidates aspiring to gain admission into Gas Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
and any one Science subject.
Nigerian Tertiary Institutions Offering Crop Production and Horticulture Course