If you are planning to study Software Engineering at Olusegun Agagu University of Science and Technology formally known as Ondo State University of Science and Technology located in Ondo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. OAUSTECH was established in 2020 by the Ondo State Government to advance science and technology education and promote innovation-driven research for economic development. This page explains everything you need to know to increase your chances of gaining admission into OAUSTECH.
Does Olusegun Agagu University of Science and Technology (OAUSTECH) offer Software Engineering?
No, Olusegun Agagu University of Science and Technology does not offer Software Engineering under its Faculty of Data and Decision Sciences. However, since our course list is updated regularly, you can visit the courses available at Olusegun Agagu University of Science and Technology (OAUSTECH) below to check if the Software Engineering course under the Faculty of Data and Decision Sciences has been updated.
Admission Requirements for Software Engineering When Accredited in Olusegun Agagu University of Science and Technology (OAUSTECH)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Software Engineering department under Faculty of Data and Decision Sciences, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subjects.
JAMB Subject Combination
Biology, Chemistry, Agric Science, Economics and Geography.
OAUSTECH Cut-Off Mark for Software Engineering
The general UTME cut-off mark is 180, but due to the variation of Software Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from OAUSTECH Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other OAUSTECH Science Courses with their Requirements
1. Polymer Engineering
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Polymer Engineering department.
any other Science subject.
2. Gas Engineering
To study this course, the minimum requirement for applicants seeking admission to the Gas Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
and any one Science subject.
3. Geology
To study this course, candidates aspiring to gain admission into Geology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other relevant subject.
4. Biological Science
To study this course, the minimum requirement for applicants seeking admission to the Biological Science department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Any other relevant Science subject.
5. Food Science and Technology (FT)
To study this course, the minimum requirement for applicants seeking admission to the Food Science and Technology (FT) department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other relevant subject from;
Biology / Agricultural Science, Physics, Basic Catering and Food Services, Bakery and Confectionaries,
6. Chemical Science
To study this course, candidates seeking admission into the Chemical Science department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
7. Geophysics
To study this course, candidates seeking admission into the Geophysics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Nigerian Universities Offering Software Engineering Course