If you are planning to study Physics with Computational Modeling at Osun State University located in Osun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. UNIOSUN was established in 1991 by the Osun State Government to expand access to university education and promote research, innovation, and academic excellence in Nigeria. This page explains everything you need to know to increase your chances of gaining admission into UNIOSUN.
Does Osun State University (UNIOSUN) offer Physics with Computational Modeling?
No, Osun State University does not offer Physics with Computational Modeling under its Faculty of Science. However, since our course list is updated regularly, you can visit the courses available at Osun State University (UNIOSUN) below to check if the Physics with Computational Modeling course under the Faculty of Science has been updated.
Admission Requirements for Physics with Computational Modeling When Accredited in Osun State University (UNIOSUN)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Physics with Computational Modeling department under Faculty of Science.
Chemistry, Mathematics and
any other Science subject from:
Biology or Agricultural Science.
UNIOSUN Cut-Off Mark for Physics with Computational Modeling
The general UTME cut-off mark is 180, but due to the variation of Physics with Computational Modeling cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNIOSUN Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNIOSUN Science Courses with their Requirements
1. Forestry
To study this course, candidates seeking admission into the Forestry department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Further Mathematics and Statistics.
2. Microbiology
To study this course, candidates seeking admission into the Microbiology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
3. Building
To study this course, the minimum requirement for applicants seeking admission to the Building department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be;
Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
4. Vocational and Technical Education
To study this course, candidates aspiring to gain admission into Vocational and Technical Education department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other relevant subject of specialization.
5. Medicine and Surgery
To study this course, the minimum requirement for applicants seeking admission to the Medicine and Surgery department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
6. Medical Laboratory Science
To study this course, candidates seeking admission into the Medical Laboratory Science department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
7. Agricultural Extension and Rural Development
To study this course, the minimum requirement for applicants seeking admission to the Agricultural Extension and Rural Development department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Chemistry, Biology / Agricultural Science
Geography, Physics and Economics.
Nigerian Tertiary Institutions Offering Physics with Computational Modeling Course