If you are planning to study Metallurgical and Material Engineering at St. Mary Polytechnic, Kwamba located in Niger State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into St. Mary Polytechnic.
Does St. Mary Polytechnic, Kwamba offer Metallurgical and Material Engineering?
No, St. Mary Polytechnic, Kwamba does not offer Metallurgical and Material Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at St. Mary Polytechnic, Kwamba below to check if the Metallurgical and Material Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Metallurgical and Material Engineering When Accredited in St. Mary Polytechnic, Kwamba
O’Level Requirements
To study this course, candidates seeking admission into the Metallurgical and Material Engineering department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
one other Science subject.
St. Mary Polytechnic Cut-Off Mark for Metallurgical and Material Engineering
The general UTME cut-off mark is 180, but due to the variation of Metallurgical and Material Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from St. Mary Polytechnic Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other St. Mary Polytechnic Science Courses with their Requirements
Electrical / Electronic Engineering Technology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Electrical / Electronic Engineering Technology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science Subject.
Computer Engineering
SSCE Requirements
To study this course, candidates aspiring to gain admission into Computer Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Computer Science (CS)
SSCE Requirements
To study this course, candidates seeking admission into the Computer Science (CS) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other Science subjects.
Nigerian Tertiary Institutions Offering Metallurgical and Material Engineering Course