If you are planning to study Glass Technology at Tansian University, Oba located in Anambra State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. TANU was established in 2000 by the Tansian Mission in Nigeria as a private Catholic university in Oba, Anambra State, to provide value-based higher education and promote academic excellence. This page explains everything you need to know to increase your chances of gaining admission into TANU.
Does Tansian University (TANU), Oba offer Glass Technology?
No, Tansian University, Oba does not offer Glass Technology under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Tansian University (TANU), Oba below to check if the Glass Technology course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Glass Technology When Accredited in Tansian University (TANU), Oba
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Glass Technology department under Faculty of Engineering / Technology.
Spinning, Weaving, Surface Design and Printing, Bleaching, Dyeing and Finishing, Ceramics, Graphic Design, Graphic Printing, Decorative Painting,
Spray Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Building / Engineering Drawing, General Wood Work.
TANU Cut-Off Mark for Glass Technology
The general UTME cut-off mark is 180, but due to the variation of Glass Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from TANU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other TANU Science Courses with their Requirements
1. Education and Biology
To study this course, the minimum requirement for applicants seeking admission to the Education and Biology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
2. Chemistry
To study this course, candidates aspiring to gain admission into Chemistry department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
3. Architecture
To study this course, candidates aspiring to gain admission into Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
4. Biology
To study this course, candidates seeking admission into the Biology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Mathematics / Physics and
any one other relevant subject.
5. Biochemistry
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Biochemistry department.
6. Industrial Chemistry
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Industrial Chemistry department.
Biology / Agricultural Science.
7. Computer Science (CS)
To study this course, candidates aspiring to gain admission into Computer Science (CS) department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other Science subjects.
Nigerian Tertiary Institutions Offering Glass Technology Course