If you are planning to study Vocational and Technical Education at Tansian University, Oba located in Anambra State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. TANU was established in 2000 by the Tansian Mission in Nigeria as a private Catholic university in Oba, Anambra State, to provide value-based higher education and promote academic excellence. This page explains everything you need to know to increase your chances of gaining admission into TANU.
Does Tansian University (TANU), Oba offer Vocational and Technical Education?
No, Tansian University, Oba does not offer Vocational and Technical Education under its Faculty of Education. However, since our course list is updated regularly, you can visit the courses available at Tansian University (TANU), Oba below to check if the Vocational and Technical Education course under the Faculty of Education has been updated.
Admission Requirements for Vocational and Technical Education When Accredited in Tansian University (TANU), Oba
O’Level Requirements
To study this course, candidates seeking admission into the Vocational and Technical Education department under Faculty of Education, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other relevant subject of specialization.
JAMB Subject Combination
any two (2) relevant subjects.
TANU Cut-Off Mark for Vocational and Technical Education
The general UTME cut-off mark is 180, but due to the variation of Vocational and Technical Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from TANU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other TANU Science Courses with their Requirements
1. Architecture
To study this course, candidates aspiring to gain admission into Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
2. Biochemistry
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Biochemistry department.
3. Industrial Chemistry
To study this course, the minimum requirement for applicants seeking admission to the Industrial Chemistry department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology / Agricultural Science.
4. Chemistry
To study this course, candidates aspiring to gain admission into Chemistry department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
5. Computer Science (CS)
To study this course, the minimum requirement for applicants seeking admission to the Computer Science (CS) department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other Science subjects.
6. Nursing (Science)
To study this course, candidates aspiring to gain admission into Nursing (Science) department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
7. Biology
To study this course, candidates aspiring to gain admission into Biology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Mathematics / Physics and
any one other relevant subject.
Nigerian Universities Offering Vocational and Technical Education Course