If you are planning to study Ecotourism and Wildlife Management at The Technical University, Ibadan located in Oyo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into TECH-U.
Does The Technical University, Ibadan (TECH-U) offer Ecotourism and Wildlife Management?
No, The Technical University, Ibadan does not offer Ecotourism and Wildlife Management under its Faculty of Renewable and Natural Resources. However, since our course list is updated regularly, you can visit the courses available at The Technical University, Ibadan (TECH-U) below to check if the Ecotourism and Wildlife Management course under the Faculty of Renewable and Natural Resources has been updated.
Admission Requirements for Ecotourism and Wildlife Management When Accredited in The Technical University, Ibadan (TECH-U)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Ecotourism and Wildlife Management department under Faculty of Renewable and Natural Resources, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology or Agricultural Science,
and any two (2) subjects from
Economics and at least ‘O’ Level pass in Physics.
JAMB Subject Combination
Biology / Agricultural Science
Economics, Mathematics and Physics.
TECH-U Cut-Off Mark for Ecotourism and Wildlife Management
The general UTME cut-off mark is 180, but due to the variation of Ecotourism and Wildlife Management cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from TECH-U Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other TECH-U Science Courses with their Requirements
Civil Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Civil Engineering department.
Architecture
SSCE Requirements
To study this course, candidates seeking admission into the Architecture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Petroleum Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Petroleum Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Mathematics
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Mathematics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other relevant subjects.
Building Technology (BT)
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Building Technology (BT) department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be; Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
Physics With Electronics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Physics With Electronics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject from Further Mathematics and Biology / Agricultural Science.
Industrial and Production Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Industrial and Production Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
Nigerian Tertiary Institutions Offering Ecotourism and Wildlife Management Course