If you are planning to study Chemical and Polymer Engineering at Topfaith University, Mkpatak located in Akwa Ibom State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. Topfaith University, Mkpatak was established in 2015 by the Topfaith Group as a private university in Mkpatak, Akwa Ibom State, to provide quality higher education with strong emphasis on discipline, innovation, and moral values. This page explains everything you need to know to increase your chances of gaining admission into Topfaith University, Mkpatak.
Does Topfaith University, Mkpatak offer Chemical and Polymer Engineering?
No, Topfaith University, Mkpatak does not offer Chemical and Polymer Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Topfaith University, Mkpatak below to check if the Chemical and Polymer Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Chemical and Polymer Engineering When Accredited in Topfaith University, Mkpatak
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Chemical and Polymer Engineering department under Faculty of Engineering / Technology.
any other Science subject.
Topfaith University, Mkpatak Cut-Off Mark for Chemical and Polymer Engineering
The general UTME cut-off mark is 180, but due to the variation of Chemical and Polymer Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Topfaith University, Mkpatak Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Topfaith University, Mkpatak Science Courses with their Requirements
1. Petroleum and Gas Engineering
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Petroleum and Gas Engineering department.
and any one Science subject.
2. Biochemistry
To study this course, candidates aspiring to gain admission into Biochemistry department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
3. Electrical / Electronics Engineering
To study this course, candidates seeking admission into the Electrical / Electronics Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
4. Computer Science (CS)
To study this course, candidates seeking admission into the Computer Science (CS) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other Science subjects.
5. Mathematics
To study this course, candidates aspiring to gain admission into Mathematics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other relevant subjects.
6. Physics With Electronics
To study this course, the minimum requirement for applicants seeking admission to the Physics With Electronics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject from Further Mathematics and Biology / Agricultural Science.
7. Software Engineering
To study this course, the minimum requirement for applicants seeking admission to the Software Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subjects.
Nigerian Tertiary Institutions Offering Chemical and Polymer Engineering Course