If you are planning to study Crop Production at University of Benin located in Edo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. UNIBEN was established in 1970 by the Midwest Regional Government (now Edo State). It is one of Nigeria’s first-generation universities, created to promote higher education, research, and national development. This page explains everything you need to know to increase your chances of gaining admission into UNIBEN.
Does University of Benin (UNIBEN) offer Crop Production?
No, University of Benin does not offer Crop Production under its Faculty of Agriculture. However, since our course list is updated regularly, you can visit the courses available at University of Benin (UNIBEN) below to check if the Crop Production course under the Faculty of Agriculture has been updated.
Admission Requirements for Crop Production When Accredited in University of Benin (UNIBEN)
O’Level Requirements
To study this course, candidates seeking admission into the Crop Production department under Faculty of Agriculture, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology / Agricultural Science,
one Science/Social Science subject and
at least ‘O’ Level pass in Physics.
JAMB Subject Combination
Biology / Agriculture and
UNIBEN Cut-Off Mark for Crop Production
The general UTME cut-off mark is 180, but due to the variation of Crop Production cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNIBEN Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNIBEN Science Courses with their Requirements
1. Architecture
To study this course, candidates aspiring to gain admission into Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
2. Computer Science (CS)
To study this course, the minimum requirement for applicants seeking admission to the Computer Science (CS) department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other Science subjects.
3. Plant Science and Biotechnology
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Plant Science and Biotechnology department.
4. Geology
To study this course, candidates seeking admission into the Geology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other relevant subject.
5. Mathematics and Economics
To study this course, the minimum requirement for applicants seeking admission to the Mathematics and Economics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other two (2) subjects selected from:
Science or Social Sciences at not more than two (2) sittings.
6. Electrical / Electronics Engineering
To study this course, the minimum requirement for applicants seeking admission to the Electrical / Electronics Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
7. Health Education
To study this course, the minimum requirement for applicants seeking admission to the Health Education department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other relevant subjects.
Nigerian Universities Offering Crop Production Course