If you are planning to study Health and Safety Education at University of Benin located in Edo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. UNIBEN was established in 1970 by the Midwest Regional Government (now Edo State). It is one of Nigeria’s first-generation universities, created to promote higher education, research, and national development. This page explains everything you need to know to increase your chances of gaining admission into UNIBEN.
Does University of Benin (UNIBEN) offer Health and Safety Education?
No, University of Benin does not offer Health and Safety Education under its Faculty of Health and Medical Sciences. However, since our course list is updated regularly, you can visit the courses available at University of Benin (UNIBEN) below to check if the Health and Safety Education course under the Faculty of Health and Medical Sciences has been updated.
Admission Requirements for Health and Safety Education When Accredited in University of Benin (UNIBEN)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Health and Safety Education department under Faculty of Health and Medical Sciences.
any three (3) Science Subjects from:
JAMB Subject Combination
any two (2) Arts subjects.
UNIBEN Cut-Off Mark for Health and Safety Education
The general UTME cut-off mark is 230, but due to the variation of Health and Safety Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNIBEN Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNIBEN Science Courses with their Requirements
1. Environmental Management and Toxicology
To study this course, candidates aspiring to gain admission into Environmental Management and Toxicology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
2. Quantity Surveying (QS)
To study this course, the minimum requirement for applicants seeking admission to the Quantity Surveying (QS) department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any of Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further. Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall, Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity.
3. Electrical / Electronics Engineering
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Electrical / Electronics Engineering department.
any other Science subject.
4. Civil Engineering
To study this course, candidates aspiring to gain admission into Civil Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
5. Chemistry
To study this course, candidates seeking admission into the Chemistry department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
6. Mechanical Engineering
To study this course, candidates seeking admission into the Mechanical Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant Science subjects.
7. Chemical Engineering
To study this course, candidates aspiring to gain admission into Chemical Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
Nigerian Tertiary Institutions Offering Health and Safety Education Course