If you are planning to study Metalwork Technology Education at University of Benin located in Edo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. UNIBEN was established in 1970 by the Midwest Regional Government (now Edo State). It is one of Nigeria’s first-generation universities, created to promote higher education, research, and national development. This page explains everything you need to know to increase your chances of gaining admission into UNIBEN.
Does University of Benin (UNIBEN) offer Metalwork Technology Education?
No, University of Benin does not offer Metalwork Technology Education under its Faculty of Education. However, since our course list is updated regularly, you can visit the courses available at University of Benin (UNIBEN) below to check if the Metalwork Technology Education course under the Faculty of Education has been updated.
Admission Requirements for Metalwork Technology Education When Accredited in University of Benin (UNIBEN)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Metalwork Technology Education department under Faculty of Education, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology / Agricultural Science, Physics, or Chemistry
and two (2) from General Science / Integrated Science, Technical Drawing / Fine Art, Geography, Health Science Food and Nutrition, Physical and Health Education, Auto Technical, Building, Electrical Electronic, Metal Work and Wood Work.
UNIBEN Cut-Off Mark for Metalwork Technology Education
The general UTME cut-off mark is 180, but due to the variation of Metalwork Technology Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNIBEN Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNIBEN Science Courses with their Requirements
1. Mechanical Engineering
To study this course, candidates seeking admission into the Mechanical Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant Science subjects.
2. Physical Education
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Physical Education department.
Biology or its Equivalent,
any two (2) relevant subjects.
3. Anatomy
To study this course, candidates aspiring to gain admission into Anatomy department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
4. Optometry
To study this course, candidates seeking admission into the Optometry department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Physics, Chemistry, Biology and
Additional / Further Mathematics.
5. Animal Science
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Animal Science department.
Biology / Agric Science, and
any one from Physics, Geography or Economics.
6. Agriculture
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Agriculture department.
Biology / Agricultural Science,
Mathematics / Physics, and
7. Pure and Applied Mathematics
To study this course, the minimum requirement for applicants seeking admission to the Pure and Applied Mathematics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology, Agricultural Science, or Geography
Nigerian Tertiary Institutions Offering Metalwork Technology Education Course