If you are planning to study Prosthesis and Orthopaedic Technology at University of Benin located in Edo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into UNIBEN.
Does University of Benin (UNIBEN) offer Prosthesis and Orthopaedic Technology?
No, University of Benin does not offer Prosthesis and Orthopaedic Technology under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at University of Benin (UNIBEN) below to check if the Prosthesis and Orthopaedic Technology course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Prosthesis and Orthopaedic Technology When Accredited in University of Benin (UNIBEN)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Prosthesis and Orthopaedic Technology department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
UNIBEN Cut-Off Mark for Prosthesis and Orthopaedic Technology
The general UTME cut-off mark is 180, but due to the variation of Prosthesis and Orthopaedic Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNIBEN Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNIBEN Science Courses with their Requirements
Animal and Environmental Biology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Animal and Environmental Biology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subject.
Production Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Production Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
Pure and Applied Mathematics
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Pure and Applied Mathematics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology, Agricultural Science, or Geography
Physics / Industrial Physics
SSCE Requirements
To study this course, candidates seeking admission into the Physics / Industrial Physics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject from:
Biology or Agricultural Science.
Technical Education
SSCE Requirements
To study this course, candidates aspiring to gain admission into Technical Education department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any three (3) relevant subjects.
Architecture
SSCE Requirements
To study this course, candidates seeking admission into the Architecture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Physical Education
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Physical Education department.
Biology or its Equivalent,
any two (2) relevant subjects.
Nigerian Tertiary Institutions Offering Prosthesis and Orthopaedic Technology Course