If you are planning to study Mechatronics Engineering at University of Calabar located in Cross River State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into UNICAL.
Does University of Calabar (UNICAL) offer Mechatronics Engineering?
No, University of Calabar does not offer Mechatronics Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at University of Calabar (UNICAL) below to check if the Mechatronics Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Mechatronics Engineering When Accredited in University of Calabar (UNICAL)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Mechatronics Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
UNICAL Cut-Off Mark for Mechatronics Engineering
The general UTME cut-off mark is 180, but due to the variation of Mechatronics Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNICAL Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNICAL Science Courses with their Requirements
Architecture
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Architecture department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Medicine and Surgery
SSCE Requirements
To study this course, candidates seeking admission into the Medicine and Surgery department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Statistics
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Statistics department.
any other relevant subject.
Environmental Education
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Environmental Education department.
any three (3) relevant subjects from:
Biology, Chemistry, Physics,
Health Science and Agricultural Science.
Technology and Vocational Education
SSCE Requirements
To study this course, candidates aspiring to gain admission into Technology and Vocational Education department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any three (3) other relevant subjects.
Medical Laboratory Science
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Medical Laboratory Science department.
Agriculture
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Agriculture department.
Biology / Agricultural Science,
Mathematics / Physics, and
Nigerian Universities Offering Mechatronics Engineering Course