If you are planning to study Polymer and Textile Engineering at University of Calabar located in Cross River State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into UNICAL.
Does University of Calabar (UNICAL) offer Polymer and Textile Engineering?
No, University of Calabar does not offer Polymer and Textile Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at University of Calabar (UNICAL) below to check if the Polymer and Textile Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Polymer and Textile Engineering When Accredited in University of Calabar (UNICAL)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Polymer and Textile Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
UNICAL Cut-Off Mark for Polymer and Textile Engineering
The general UTME cut-off mark is 180, but due to the variation of Polymer and Textile Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNICAL Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNICAL Science Courses with their Requirements
1. Technology and Vocational Education
To study this course, candidates seeking admission into the Technology and Vocational Education department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any three (3) other relevant subjects.
2. Dentistry and Dental Surgery
To study this course, candidates seeking admission into the Dentistry and Dental Surgery department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
3. Surveying and Geoinformatics
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Surveying and Geoinformatics department.
Joinery, Carpentry, Decorative Painting, Lining, Sign & Design, Wall Hanging, Colour Mixing / Matching & Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity,
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block Laying, Concreting, Wall, Floors and Ceiling Finishing.
4. Forestry and Wildlife Management
To study this course, the minimum requirement for applicants seeking admission to the Forestry and Wildlife Management department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Further Mathematics and Statistics.
5. Environmental Education
To study this course, candidates seeking admission into the Environmental Education department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any three (3) relevant subjects from:
Biology, Chemistry, Physics,
Health Science and Agricultural Science.
6. Pure Chemistry
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Pure Chemistry department.
7. Applied Chemistry
To study this course, candidates seeking admission into the Applied Chemistry department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Nigerian Tertiary Institutions Offering Polymer and Textile Engineering Course