If you are planning to study Applied Biology and Biotechnology at University of Delta, Agbor located in Delta State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. UNIDEL was established in 2021 by the Delta State Government through the upgrade of Delta State Polytechnic, Ozoro and other institutions into a full university to expand access to higher education. This page explains everything you need to know to increase your chances of gaining admission into UNIDEL.
Does University of Delta (UNIDEL), Agbor offer Applied Biology and Biotechnology?
No, University of Delta, Agbor does not offer Applied Biology and Biotechnology under its Faculty of Science. However, since our course list is updated regularly, you can visit the courses available at University of Delta (UNIDEL), Agbor below to check if the Applied Biology and Biotechnology course under the Faculty of Science has been updated.
Admission Requirements for Applied Biology and Biotechnology When Accredited in University of Delta (UNIDEL), Agbor
O’Level Requirements
To study this course, candidates seeking admission into the Applied Biology and Biotechnology department under Faculty of Science, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
JAMB Subject Combination
either Physics or Mathematics.
UNIDEL Cut-Off Mark for Applied Biology and Biotechnology
The general UTME cut-off mark is 180, but due to the variation of Applied Biology and Biotechnology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNIDEL Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNIDEL Science Courses with their Requirements
1. Education and Biology
To study this course, candidates seeking admission into the Education and Biology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
2. Computer Science (CS)
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Computer Science (CS) department.
any two (2) other Science subjects.
3. Mechanical Engineering
To study this course, candidates seeking admission into the Mechanical Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant Science subjects.
4. Surveying and Geoinformatics
To study this course, the minimum requirement for applicants seeking admission to the Surveying and Geoinformatics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Joinery, Carpentry, Decorative Painting, Lining, Sign & Design, Wall Hanging, Colour Mixing / Matching & Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity,
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block Laying, Concreting, Wall, Floors and Ceiling Finishing.
5. Education and Integrated Science
To study this course, the minimum requirement for applicants seeking admission to the Education and Integrated Science department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Any other four (4) relevant subjects
6. Electrical / Electronics Engineering
To study this course, candidates aspiring to gain admission into Electrical / Electronics Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
7. Biotechnology
To study this course, candidates seeking admission into the Biotechnology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Nigerian Tertiary Institutions Offering Applied Biology and Biotechnology Course