If you are planning to study Wood Production Engineering at University of Delta, Agbor located in Delta State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into UNIDEL.
Does University of Delta (UNIDEL), Agbor offer Wood Production Engineering?
No, University of Delta, Agbor does not offer Wood Production Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at University of Delta (UNIDEL), Agbor below to check if the Wood Production Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Wood Production Engineering When Accredited in University of Delta (UNIDEL), Agbor
O’Level Requirements
To study this course, candidates seeking admission into the Wood Production Engineering department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
UNIDEL Cut-Off Mark for Wood Production Engineering
The general UTME cut-off mark is 180, but due to the variation of Wood Production Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNIDEL Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNIDEL Science Courses with their Requirements
Architecture
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Architecture department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Electrical / Electronics Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Electrical / Electronics Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
Mathematics
SSCE Requirements
To study this course, candidates seeking admission into the Mathematics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant subjects.
Environmental Management and Toxicology
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Environmental Management and Toxicology department.
Education and Integrated Science
SSCE Requirements
To study this course, candidates seeking admission into the Education and Integrated Science department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Any other four (4) relevant subjects
Agricultural Science and Education
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Agricultural Science and Education department.
Biology/Agricultural Science,
any other relevant subject.
Education and Physics
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Education and Physics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subjects or NTC / NBC.
Nigerian Tertiary Institutions Offering Wood Production Engineering Course