If you are planning to study Prosthesis and Orthopaedic Technology at University of Ilorin located in Kwara State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into UNILORIN.
Does University of Ilorin (UNILORIN) offer Prosthesis and Orthopaedic Technology?
No, University of Ilorin does not offer Prosthesis and Orthopaedic Technology under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at University of Ilorin (UNILORIN) below to check if the Prosthesis and Orthopaedic Technology course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Prosthesis and Orthopaedic Technology When Accredited in University of Ilorin (UNILORIN)
O’Level Requirements
To study this course, candidates seeking admission into the Prosthesis and Orthopaedic Technology department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
UNILORIN Cut-Off Mark for Prosthesis and Orthopaedic Technology
The general UTME cut-off mark is 180, but due to the variation of Prosthesis and Orthopaedic Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNILORIN Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNILORIN Science Courses with their Requirements
Education and Biology
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Biology department.
Biochemistry
SSCE Requirements
To study this course, candidates seeking admission into the Biochemistry department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Architecture
SSCE Requirements
To study this course, candidates seeking admission into the Architecture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Education and Physics
SSCE Requirements
To study this course, candidates seeking admission into the Education and Physics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
two (2) other Science subjects or NTC / NBC.
Education and Mathematics
SSCE Requirements
To study this course, candidates seeking admission into the Education and Mathematics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
one (1) other Science subject, and
any other relevant subjects.
Medicine and Surgery
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Medicine and Surgery department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Health Education
SSCE Requirements
To study this course, candidates aspiring to gain admission into Health Education department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other relevant subjects.
Nigerian Tertiary Institutions Offering Prosthesis and Orthopaedic Technology Course