If you are planning to study Industrial Technical Education at University of Jos located in Plateau State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. UNIJOS was established in 1971 by the Federal Government of Nigeria to provide higher education opportunities in the North-Central region and support national development through research and teaching. This page explains everything you need to know to increase your chances of gaining admission into UNIJOS.
Does University of Jos (UNIJOS) offer Industrial Technical Education?
No, University of Jos does not offer Industrial Technical Education under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at University of Jos (UNIJOS) below to check if the Industrial Technical Education course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Industrial Technical Education When Accredited in University of Jos (UNIJOS)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Industrial Technical Education department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Mathematics / Physics and
any other three (3) relevant subjects.
UNIJOS Cut-Off Mark for Industrial Technical Education
The general UTME cut-off mark is 180, but due to the variation of Industrial Technical Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNIJOS Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNIJOS Science Courses with their Requirements
1. Dentistry and Dental Surgery
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Dentistry and Dental Surgery department.
2. Quantity Surveying (QS)
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Quantity Surveying (QS) department.
any of Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further. Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall, Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity.
3. Pharmacy
To study this course, the minimum requirement for applicants seeking admission to the Pharmacy department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
4. Mechanical Engineering
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Mechanical Engineering department.
any two (2) other relevant Science subjects.
5. Veterinary Medicine
To study this course, the minimum requirement for applicants seeking admission to the Veterinary Medicine department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
6. Education and Biology
To study this course, candidates seeking admission into the Education and Biology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
7. Mathematics
To study this course, candidates aspiring to gain admission into Mathematics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other relevant subjects.
Nigerian Tertiary Institutions Offering Industrial Technical Education Course