If you are planning to study Mechanical and Metallurgical Engineering at University of Jos located in Plateau State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. UNIJOS was established in 1971 by the Federal Government of Nigeria to provide higher education opportunities in the North-Central region and support national development through research and teaching. This page explains everything you need to know to increase your chances of gaining admission into UNIJOS.
Does University of Jos (UNIJOS) offer Mechanical and Metallurgical Engineering?
No, University of Jos does not offer Mechanical and Metallurgical Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at University of Jos (UNIJOS) below to check if the Mechanical and Metallurgical Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Mechanical and Metallurgical Engineering When Accredited in University of Jos (UNIJOS)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Mechanical and Metallurgical Engineering department under Faculty of Engineering / Technology.
one (1) other Science subject.
UNIJOS Cut-Off Mark for Mechanical and Metallurgical Engineering
The general UTME cut-off mark is 180, but due to the variation of Mechanical and Metallurgical Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNIJOS Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNIJOS Science Courses with their Requirements
1. Education and Biology
To study this course, candidates seeking admission into the Education and Biology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
2. Mechanical Engineering
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Mechanical Engineering department.
any two (2) other relevant Science subjects.
3. Education and Integrated Science
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Integrated Science department.
Any other four (4) relevant subjects
4. Dentistry and Dental Surgery
To study this course, candidates aspiring to gain admission into Dentistry and Dental Surgery department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
5. Architecture
To study this course, candidates aspiring to gain admission into Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
6. Pharmacy
To study this course, candidates aspiring to gain admission into Pharmacy department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
7. Education and Physics
To study this course, the minimum requirement for applicants seeking admission to the Education and Physics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subjects or NTC / NBC.
Nigerian Tertiary Institutions Offering Mechanical and Metallurgical Engineering Course