If you are planning to study Prosthesis and Orthopaedic Technology at University of Jos located in Plateau State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into UNIJOS.
Does University of Jos (UNIJOS) offer Prosthesis and Orthopaedic Technology?
No, University of Jos does not offer Prosthesis and Orthopaedic Technology under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at University of Jos (UNIJOS) below to check if the Prosthesis and Orthopaedic Technology course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Prosthesis and Orthopaedic Technology When Accredited in University of Jos (UNIJOS)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Prosthesis and Orthopaedic Technology department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
UNIJOS Cut-Off Mark for Prosthesis and Orthopaedic Technology
The general UTME cut-off mark is 180, but due to the variation of Prosthesis and Orthopaedic Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNIJOS Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNIJOS Science Courses with their Requirements
Education and Chemistry
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Education and Chemistry department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology and Agricultural Science.
Actuarial Science
SSCE Requirements
To study this course, candidates aspiring to gain admission into Actuarial Science department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other two (2) relevant subjects.
Plant Science and Biotechnology
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Plant Science and Biotechnology department.
Geology and Mining
SSCE Requirements
To study this course, candidates seeking admission into the Geology and Mining department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any one other relevant subject.
Architecture
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Architecture department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Technical Education
SSCE Requirements
To study this course, candidates aspiring to gain admission into Technical Education department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any three (3) relevant subjects.
Nursing (Science)
SSCE Requirements
To study this course, candidates seeking admission into the Nursing (Science) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Nigerian Tertiary Institutions Offering Prosthesis and Orthopaedic Technology Course