If you are planning to study Woodwork Technology Education at University of Jos located in Plateau State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. UNIJOS was established in 1971 by the Federal Government of Nigeria to provide higher education opportunities in the North-Central region and support national development through research and teaching. This page explains everything you need to know to increase your chances of gaining admission into UNIJOS.
Does University of Jos (UNIJOS) offer Woodwork Technology Education?
No, University of Jos does not offer Woodwork Technology Education under its Faculty of Education. However, since our course list is updated regularly, you can visit the courses available at University of Jos (UNIJOS) below to check if the Woodwork Technology Education course under the Faculty of Education has been updated.
Admission Requirements for Woodwork Technology Education When Accredited in University of Jos (UNIJOS)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Woodwork Technology Education department under Faculty of Education, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any one (1) of Biology / Agricultural Science, Physics, or Chemistry and
two (2) from General Science / Integrated Science, Technical Drawing / Fine Art, Geography, Health Science Food and Nutrition, Physical and Health Education, Auto Technical, Building, Electrical Electronic, Metal Work and Wood Work.
UNIJOS Cut-Off Mark for Woodwork Technology Education
The general UTME cut-off mark is 180, but due to the variation of Woodwork Technology Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNIJOS Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNIJOS Science Courses with their Requirements
1. Education and Integrated Science
To study this course, candidates aspiring to gain admission into Education and Integrated Science department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Any other four (4) relevant subjects
2. Education and Physics
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Physics department.
two (2) other Science subjects or NTC / NBC.
3. Pharmacy
To study this course, candidates seeking admission into the Pharmacy department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
4. Plant Science and Biotechnology
To study this course, candidates seeking admission into the Plant Science and Biotechnology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
5. Actuarial Science
To study this course, candidates seeking admission into the Actuarial Science department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other two (2) relevant subjects.
6. Zoology
To study this course, candidates seeking admission into the Zoology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
two (2) other Science subject.
7. Building
To study this course, candidates seeking admission into the Building department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be;
Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
Nigerian Tertiary Institutions Offering Woodwork Technology Education Course