If you are planning to study Building and Woodwork Technology Education at University of Lagos located in Lagos State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. UNILAG was established in 1962 by the Federal Government of Nigeria as one of the first-generation universities. It was created to promote higher education, research, and national integration. This page explains everything you need to know to increase your chances of gaining admission into UNILAG.
Does University of Lagos (UNILAG) offer Building and Woodwork Technology Education?
No, University of Lagos does not offer Building and Woodwork Technology Education under its Faculty of Education. However, since our course list is updated regularly, you can visit the courses available at University of Lagos (UNILAG) below to check if the Building and Woodwork Technology Education course under the Faculty of Education has been updated.
Admission Requirements for Building and Woodwork Technology Education When Accredited in University of Lagos (UNILAG)
O’Level Requirements
To study this course, candidates seeking admission into the Building and Woodwork Technology Education department under Faculty of Education, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
UNILAG Cut-Off Mark for Building and Woodwork Technology Education
The general UTME cut-off mark is 180, but due to the variation of Building and Woodwork Technology Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNILAG Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNILAG Science Courses with their Requirements
1. Quantity Surveying (QS)
To study this course, the minimum requirement for applicants seeking admission to the Quantity Surveying (QS) department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any of Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further. Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall, Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity.
2. Botany
To study this course, candidates aspiring to gain admission into Botany department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
3. Medical Laboratory Science
To study this course, candidates seeking admission into the Medical Laboratory Science department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
4. Geography
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Geography department.
any other two (2) Science subjects.
5. Microbiology
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Microbiology department.
6. Education and Physics
To study this course, candidates aspiring to gain admission into Education and Physics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
two (2) other Science subjects or NTC / NBC.
7. Mechanical Engineering
To study this course, the minimum requirement for applicants seeking admission to the Mechanical Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other relevant Science subjects.
Nigerian Tertiary Institutions Offering Building and Woodwork Technology Education Course