If you are planning to study Livestock Production Technology at University of Lagos located in Lagos State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. UNILAG was established in 1962 by the Federal Government of Nigeria as one of the first-generation universities. It was created to promote higher education, research, and national integration. This page explains everything you need to know to increase your chances of gaining admission into UNILAG.
Does University of Lagos (UNILAG) offer Livestock Production Technology?
No, University of Lagos does not offer Livestock Production Technology under its Faculty of Agriculture. However, since our course list is updated regularly, you can visit the courses available at University of Lagos (UNILAG) below to check if the Livestock Production Technology course under the Faculty of Agriculture has been updated.
Admission Requirements for Livestock Production Technology When Accredited in University of Lagos (UNILAG)
O’Level Requirements
To study this course, candidates seeking admission into the Livestock Production Technology department under Faculty of Agriculture, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology / Agricultural Science.
JAMB Subject Combination
Biology / Agricultural Science.
UNILAG Cut-Off Mark for Livestock Production Technology
The general UTME cut-off mark is 180, but due to the variation of Livestock Production Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNILAG Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNILAG Science Courses with their Requirements
1. Building
To study this course, candidates aspiring to gain admission into Building department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be;
Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
2. Biomedical Engineering
To study this course, the minimum requirement for applicants seeking admission to the Biomedical Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
3. Nursing (Science)
To study this course, candidates seeking admission into the Nursing (Science) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
4. Metallurgical and Material Engineering
To study this course, candidates seeking admission into the Metallurgical and Material Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
one other Science subject.
5. Meteorology and Climate Change
To study this course, candidates seeking admission into the Meteorology and Climate Change department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Chemistry / Geography and
any other one (1) relevant subject.
6. Physiology
To study this course, candidates seeking admission into the Physiology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
7. Biochemistry
To study this course, the minimum requirement for applicants seeking admission to the Biochemistry department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Nigerian Tertiary Institutions Offering Livestock Production Technology Course